SAFETY & STORAGE
Position:
Store tanks upright, secured to prevent tipping.
Location:
Place in a cool, ventilated area away from walkways or stairs.
Safety:
Keep at least 20 feet from heat sources or combustibles.
Separation:
Store full and empty tanks separately.
Protection:
Use a hand truck for transport. Never drag or lift by the valve cap.
Temperature:
Maintain below 125°F (52°C) and out of direct sunlight.
HOW TO USE
Before You Begin
-
Ensure the main valve on the CO₂ cylinder is closed.
-
Close the working pressure knob on the regulator (counter-clockwise).
-
Apply thread sealant tape clockwise on the regulator’s male threads for a tight seal.
-
Confirm the regulator’s thread type (e.g., CGA 320) matches your cylinder.
-
For beverage dispensers, use a tank without a siphon tube for direct connection.
Step 1: Attach the Regulator
-
Screw the regulator onto the CO₂ cylinder finger-tight.
-
Use a wrench to tighten until secure.
Step 2: Connect Tubing & Components
-
Attach tubing or a bubble counter to the regulator’s outlet.
-
Run the tubing to your device (diffuser, keg coupler, or dispenser).
-
Add a check valve for aquarium setups.
-
Ensure a secure connection before turning on the gas.
Step 3: Turn On the Gas & Adjust Pressure
-
Slowly open the main valve.
-
Check both gauges — one shows cylinder pressure, the other output pressure.
-
Turn the working pressure knob until desired PSI is reached (e.g., ~25 PSI for aquarium or beverage systems).
-
Power on the solenoid if included.
-
Check for leaks at every connection.
